Wohler eAMP1-S8-DA User Manual page 59

8. Mute/Unmute: A Mute/Unmute control is provided for each channel,
although the adjustment will affect all channels in the Cluster. This allows the
operator to just see the meters for certain channels and not hear the audio.
This is an alternate action control.
9. The Global Phase Indicators tab is as shown in Figure 4-16. It allows you
to select which channel pairs will receive a phase meter on the Metering
Screen in this Preset. Generally, it is useful to monitor the relative phase of
stereo pairs. However, sometimes each channel of a pair is unrelated to
each other. This can be because the channels are used to convey two
independent monophonic signals or that one channel may be a Center
channel and the other may be a Low Frequency Effects channel. In these
instances, the Phase Indicator would almost always indicate an out of phase
condition. Because this would be a needless distraction to the operator,
switches are provided on this tab to individually turn phase monitoring for
each channel pair on or off. By default, the settings for a Preset are the same
as the system-wide configuration set on the System Preference tab.
However, to make unique settings for this Preset, uncheck Apply Global
Phase Indicator Settings and then simply click each switch to the desired
on or off position. Select All and Reset All buttons are also provided.
Figure 4–16: Global Phase Indicator Enable / Disable
eAMP1-S8-DA
Page 59