Table of Contents
Advertisement
Unit Configuration
Touching the Unit Config selection on the Unit Settings Menu proceeds to the
Unit Config Menu. This menu is shown in Figure 2-20.
The controls function as follows:
1. Brightness: This setting adjusts the brightness of the display screen. Touch
the left pointing arrow to dim the brightness or touch the right pointing arrow
to increase the brightness.
2. AES termination: AES signals should have one and only one termination.
This termination should physically be at the last destination of an AES coax
cable. If the eAMP1-S8-DA is the last connection in a series of AES
connections, then its terminations should be turned on. A symptom of too
many terminations (or no termination) is that no signal appears to be
present on the AES input. Touch the On - Off switch to change the
termination setting.
3. Meter Mode: This setting determines how many meters will be displayed.
On the eAMP1-S8-DA it shows 8 meters.
Touch Back to exit this menu.
eAMP1-S8-DA
Figure 2-20: Unit Configuration Menu
Unit Config
Cancel & Exit
<
Brightness
AES
On
Termination
Meter
<
Mode
Page 26
Save & Exit
>
50
>
8
Advertisement
Table of Contents
