Table of Contents
Advertisement
Updating Multiple Units Remotely
Use the following steps to update one or more eAMP1-S8-DA units remotely by
transferring the software from a previously updated eAMP1-S8-DA:
1. If any of the eAMP1-S8-DA units that you intend to update remotely may be
in use, contact the people using them and let them know what you will be
doing. The eAMP1-S8-DA units being updated will be temporarily out of
service.
2. Use the Wohler Web GUI to connect to an eAMP1-S8-DA already containing
the latest update. This will be referred to as the Master Unit. Navigate to
the System | System Update | Remote System Update menu. The
screen shown in Figure A-12 will appear and the Web GUI will scan the
network for any active eAMP1-S8-DA units.
eAMP1-S8-DA
Note: The scanning process will take 2 minutes. Progress is shown on the
screen. If for some reason you would like to stop the scan prematurely, click the
Stop Scan button.
Important:
Master Unit at a time, to avoid problems. Although you may be updating
multiple units at the same time, never attempt this process from more than one
Master Unit.
3. When the scanning is complete, a list of found eAMP1-S8-DA units will be
shown as in Figure A-13. Click either Select All or click only the Target
units that you want to update.
eAMP1-S8-DA
Figure A-12 – Scanning for eAMP1-S8-DA Units
run the scanning or updating process from
Do not
Page 82
more than one
Advertisement
Table of Contents
