Rear Panel - Wohler eAMP1-S8-DA User Manual

Display screen, as follows:
Pressing the Volume control mutes the audio and a speaker muted icon appears at
the top the Audio Meter Display:
Volume control is turned all the way counterclockwise.
5. Balance: This controls the relative left/right levels for the monitored stereo mix.
Pressing the knob will bring the balance back to center. It controls the speakers,
the headphone, and the analog outputs. As the Balance control is turned, a
graphic appears at the top of the Audio Meter Display as follows:
6. Channel: Turning this control moves a white selection box from channel to channel
on the metering screen. Press the control to solo the highlighted channel. The box
will turn blue and any other boxes will disappear. To remove the solo and return to
the previous monitoring configuration, press the Channel control once again.
7. USB: This USB 2.0 Type A connector allows you to use a flash drive (not supplied)
to perform software updates and copy system configurations to another
S8-DA
or to a PC. Refer to Appendix A of this manual to learn about performing a
software update.
8. Status: This indicator lights green when the system is powered and ready for use.
A solid or blinking yellow color indicates that the product is starting up. A red color
indicates that a system update is taking place. Refer to Appendix A for procedures
to update software.

Rear Panel

The Rear Panel is shown in Figure 2-2.
Power Connection: The eAMP1-S8-DA receives power from an AC inlet, which is a
standard IEC receptacle for 100 to 240 VAC ±10%, 50/60 Hz power connection. Four
regional AC power cords, supplied according to shipping region, are available.
eAMP1-S8-DA
This icon also displays whenever the
Figure 2-2: Rear Panel Connectors
Page 11
eAMP1-