Phase Configuration - Wohler eAMP1-S8-DA User Manual

Phase Configuration

Touching the Phase Config selection on the Unit Settings Menu proceeds to the
Phase Config Menu. This menu is shown in Figure 2-21.
The controls function as follows:
1. Pair 1 - 4: These switches allow you to select which channel pairs will
receive a phase meter on the Metering Screen. Generally, it is useful to
monitor the relative phase of stereo pairs. However, sometimes each
channel of a pair is unrelated to each other. This can be because the
channels are used to convey two independent monophonic signals or that
one channel may be a Center channel and the other may be a Low Frequency
Effects channel. In these instances, the Phase Indicator would almost always
indicate an out of phase condition. Because this would be a needless
distraction to the operator, switches are provided on this screen to
individually turn phase monitoring for each channel pair on or off.
2. Cancel & Exit: If you decide that you do not want to keep the settings you
have made on this screen, touch the Cancel & Exit button to discard the
changes and return to the Unit Settings menu.
3. Save & Exit: When you have finished making the changes you want on this
screen, touch the Save & Exit button to save the changes and return to the
Unit Settings menu.
eAMP1-S8-DA
Figure 2-21: Phase Configuration Menu
Phase
Cancel & Exit
Config
Pair - 1
Off
Pair - 3
Off
Page 27
Save & Exit
Pair - 2
Off
Pair - 4
Off