Loudness Settings - Wohler eAMP1-S8-DA User Manual

Note: Further and more detailed descriptions of all of the above Loudness terms
may be found in the ITU-R BS.1770-3 loudness standard.
The controls available on the Loudness Meter Screen are:
1. Cluster Select: You may change which Cluster is being measured by simply
touching the green Loudness reading on the Audio Meter screen. It will turn
orange and you will be able to touch other clusters and read their Loudness.
Changing clusters will reset the loudness readings and start a new calculation
on the newly selected cluster.
2. Start: When Manual Mode is selected in the Loudness Settings
screen, from a stopped condition, the Start button will reset the
gathered loudness data and begin a new reading. From a paused
condition, data will not reset as monitoring is resumed.
3. Pause: The Pause button will temporarily stop or continue
gathering loudness data. Data will not be reset using this control.
While paused, Loudness will not be measured.
4. Reset: The Reset button will reset the gathered loudness data. If
it is pressed while a loudness measurement is in progress, a new
reading will then immediately begin.
5. Stop: When Manual Mode is selected in the Loudness Settings
screen, the Stop button will stop gathering loudness data. Data will
be held for viewing and not be reset using this control.
6. Back: Touch the Back button to go to the Loudness Menu.

Loudness Settings

Loudness Measurement is available if the OPTe Package is purchased. Touch the
Loudness Settings button on the Loudness Menu to display the Loudness
Settings screen. This screen allows you to change between Manual and
Continuous Monitoring Modes, and also to set the Alarm mode. It also provides a
summary of various Loudness settings, as set in the Configuration | System
Preference | Loudness Configuration tab of the Web GUI. Refer to Figure 2-11.
eAMP1-S8-DA
Figure 2-11: Optional Loudness Settings Screen
Page 19