Chapter 4: Using Network Control; Web Browser / Control Device; First Time- Ip Assignments - Wohler HDM-320-4K-TT User Manual

CHAPTER 4: Using Network Control

The HDM-320-4K Web GUI allows you to customize the monitor configuration to
perfectly suit your needs. The following setup steps are not necessary if you intend
to use the HDM-320-4K in its default configuration or if you only make configuration
changes using the OSD menus. However, the HDM-320-4K Web GUI network
control is ideal for configuring difficult to access monitors.

Web Browser / Control Device

Any web browser application running on any networked device such as desktop or
laptop computer, tablet, or smart phone can be used with the HDM-320-4K Web
GUI.
If a tablet without a physical network connector is to be used, it needs to be linked
to a copper LAN through a Wi-Fi adaptor.
Phones are not recommended due to their smaller screen size, which would require
more scrolling.
®
The Chrome

First Time- IP Assignments

The HDM-320-4K operates with a static (fixed) IPv4 address. The address will be
192.168.1.86 when received from the factory or when reset at the front panel.
This is shown in Figure 4-2. The IP address will need to be changed to some other
address to be compatible with the customer's network address assignments. Go to
System setup, immediately after this host setup is done, to change the unit's
address.
The surest way to do this, free of possible network conflicts, is to establish a direct
peer-to-peer connection between the setup computer and the HDM-320-4K. A
10/100/1000 MHz Ethernet switch may be used in between, but is not required.
Figure 4-1 shows an example of suitable address settings for the host computer in
a Windows 7 control panel.
web browser is recommended for speed and compatibility.
Page
27