Table of Contents
Advertisement
Reading the Operator Panel and System LEDs
The following illustration shows the component location on the operator panel
Number
For more information on other system LEDs refer to "Component LEDs" on page 476.
Eserver pSeries 630 Models 6C4 and 6E4 Service Guide
30
1 Power-On Button
2 Power LED
3 Attention LED
4 SCSI Port Activity
5 Ethernet Port Activity
Component Name
1
Power-On Button
2
Power LED
3
Attention LED
4
SCSI Port Activity
5
Ethernet Port Activity
6
Operator Panel Display
7
Front Serial Connector
(FS1)
8
Service Processor Reset
Switch (Pinhole)
9
System Reset Button
6 Operator Panel Display
7 (FS1) Front Serial
Connector (RJ48 Connector)
8 Service Processor Reset
Switch (Pinhole)
9 System Reset Button
Component Description
Turns the system power on and off.
Normal State - LED is on when system is
connected to a power source.
Normal State - LED is off.
Normal State - LED is on when there is SCSI
activity.
Normal State - LED is on when there is Ethernet
activity.
Displays current status of system startup, or
diagnostic information in the event of a hardware
problem.
Serial port uses RJ48 connector. Use to plug in
external devices at the front of the system unit.
Service Personnel Use Only
Resets the system
Advertisement
Table of Contents
