Table of Contents
Advertisement
12. Locate the memory DIMMs, and determine which DIMM you want to remove.
Note: Memory DIMMs must be installed in quads (groups of 4) and in the correct
slot. The only two valid slot combinations that you can use are 1, 3, 6, and
8 OR 2, 4, 5, and 7. See the following illustration.
Number Description
M1 Memory slot 1 (J2A)
M2 Memory slot 2 (J2B)
M3 Memory slot 3(J3A)
M4 Memory slot 4(J3B)
M5 Memory slot 5(J1B)
M6 Memory slot 6(J1A)
M7 Memory slot 7(J0B)
M8 Memory slot 8(J0A)
Note: The location code column shows the location codes for processor card 1. If your system is
configured for processor card 2, substitute C2 in place of C1.
Attention:
To prevent damage to the memory DIMM and the memory DIMM
connectors, open or close the retention latches at the same time.
13. Remove the memory DIMM by pushing the tabs out and then down. The tabs'
camming action forces the memory DIMM out of the connector.
Location Code
U0.1-P1-C1-M1
U0.1-P1-C1-M2
U0.1-P1-C1-M3
U0.1-P1-C1-M4
U0.1-P1-C1-M5
U0.1-P1-C1-M6
U0.1-P1-C1-M7
U0.1-P1-C1-M8
Chapter 9. Removal and Replacement Procedures
433
Advertisement
Table of Contents
