Table of Contents
Advertisement
12. The ARE YOU SURE screen displays. Press Enter to verify the information.
Successful unconfiguration is indicated by the OK message displayed next to the
Command field at the top of the screen.
13. Press F3 to return to the PCI Hot-Plug Manager menu.
14. Select Replace/Remove a PCI Hot-Plug Adapter and press Enter. The
Replace/Remove a PCI Hot-Plug Adapter menu displays.
Note: If the PCI Hot-Plug Adapter menu indicates that the slot for the just
a. From the Replace/Remove a PCI Hot-Plug Adapter menu, select F3 to cancel.
b. Select Add PCI Hot-Plug Adapter, and press Enter. The display screen
c. On the display screen, select the indicated empty slot. Look at the replaced
d. Completely, remove the hot-plug adapter from the slot. The LED goes off.
e. Reinstall the adapter, ensuring that it is correctly seated. Press Enter.
f. Select F3 to return to the PCI Hot-Plug Adapter Menu.
g. Select Install/Configure Devices Added after IPL.
h. At the display screen, identify the PCI hot-plug slot that your adapter is using.
15. Move the cursor to select the adapter that you are removing, and press Enter.
16. Press the Tab key until the entry field displays the replace operation, and then
press Enter. Follow the instructions that display on the screen until you are
instructed to remove the adapter.
17. When you are instructed to remove the adapter from the adapter slot, disconnect
any cables that are connected to the adapter being removed.
18. Turn the locking latch, and lift the plastic stop for the adapter.
19. Carefully grasp the adapter by the edges, and pull it straight out from the PCI riser
card.
Eserver pSeries 630 Models 6C4 and 6E4 Service Guide
384
replaced adapter is reading empty, do the following:
indicates that the PCI slot is empty.
adapter and slot in your system. A slowly blinking green LED on the adapter is
indicating that the slot has been identified. Press Enter. The adapter LED is
now blinking fast, indicating that it is in the action state.
If it still shows as being empty, redo steps a through g. However, before you
reinstall the adapter, test it. If the adapter fails the test, redo steps a through g
with a new adapter.
Advertisement
Table of Contents
