Table of Contents
Advertisement
1 Spring Latch
2 Spring Activated Handle End
3 Power Supply Release Handle
5. Plug the power cable for the added power supply into the power cable connector
located on the back of the power supply.
6. Reconnect the power source to the system. The green AC Good LED located on
the power supply should come on solid.
7. Verify that the green DC Good LED on the power supply is lit. The green LED
indicates that the power supply is operating correctly.
8.
Replace the service access cover as described in "Service Access Cover
Removal (Model 6C4)" on page 357 or "Service Access Cover Removal (Model
6E4)" on page 363.
9. If you are servicing a Model 6C4, push the system drawer back into the operating
position as described in "Returning the Model 6C4 to the Operating Position" on
page 356.
10. On a Model 6C4, close the rack doors.
On a Model 6E4, close the bezel door.
4 Power Supply
5 Spring Latch Receiver Hole
6 Locking Tab
Chapter 9. Removal and Replacement Procedures
449
Advertisement
Table of Contents
