IBM eserver 630 6C4 Service Manual page 243

Table 6. Service Processor Error Codes. (continued)
Error Code Description
406F 00B1 Bus controller failure
406F 00B3 Processor/VPD problem detected
406F 00B4 Processor/VPD problem detected
406F 00B7 Insufficient hardware resources were
detected to continue IPL of the system
after processor subsystem testing and
initialization was completed
406F 00D1 Informational message
406F 0100 Memory extender 0 on processor card 1 Processor card,
406F 0101 Memory extender 2 on processor card 1 Processor card,
406F 0130 Memory extender 0 on processor card 2 Processor card,
406F 0131 Memory extender 2 on processor card 2 Processor card,
406F 0A03 Reboot message on VPD channel 3
processor card 1. Reboot is necessary
for run-time array gard to take effect.
406F 0A04 Reboot message on VPD channel 4
processor card 2. Reboot is necessary
for run-time array gard to take effect.
406F 0B00 I/O slot 0, I/O port 0 (problem outside
the CEC drawer)
406F 0B01 I/O slot 0, I/O port 1 (problem outside
the CEC drawer)
406F 0B02 I/O slot 0, I/O port 2 (problem outside
the CEC drawer)
406F 0B03 I/O slot 0, I/O port 3 (problem outside
the CEC drawer)
Action/
Possible Failing FRU
1. Check for system firmware updates
2. PCI riser card
Location: U0.1-P2
1. Check for system firmware updates
2. Processor card 1
Location: U0.1-P1-C1
1. Check for system firmware updates
2. Processor card 2
Location: U0.1-P1-C2
Go to "MAP 1540: Minimum
Configuration" on page 101.
Informational message
Location: U0.1-P1-C1
Location: U0.1-P1-C1
Location: U0.1-P1-C2
Location: U0.1-P1-C2
Reboot the system in slow mode. Run
diagnostics, then go to "MAP 0235:
System Array Self-Repair Problem
Resolution" in the RS/6000 Eserver
pSeries Diagnostic Information for
Multiple Bus Systems .
Reboot the system in slow mode. Run
diagnostics, then go to "MAP 0235:
System Array Self-Repair Problem
Resolution" in the RS/6000 Eserver
pSeries Diagnostic Information for
Multiple Bus Systems .
Go to "MAP 1540: Minimum
Configuration" on page 101.
Go to "MAP 1540: Minimum
Configuration" on page 101.
Go to "MAP 1540: Minimum
Configuration" on page 101.
Go to "MAP 1540: Minimum
Configuration" on page 101.
Chapter 5. Error Code to FRU Index
223