IBM eserver 630 6C4 Service Manual page 505

Appendix C. Service Processor Setup and Test
Attention:
and S3) on the pSeries 630 Model 6C4 and Model 6E4 systems. It does not affect the
operation of the modem attached to the Hardware Management Console (HMC).
The call-out function is normally handled by the Service Focal Point application running
on the HMC.
For your convenience, an example of a basic service processor setup checklist is
included here. Your setup may include more or fewer of the available features, so you
can adjust this checklist for your own application so that it is helpful to you.
Service Processor Setup Checklist
1. Unplug the power cord from the system.
2. Attach a local terminal for this setup procedure.
3. Plug in the system and power on the local terminal.
Attention:
4. Start the service processor menus. See Chapter 7, "Using the Service Processor"
on page 283.
5. Set the system name. See "Privileged User Menus" on page 287.
6. Enable surveillance. See "Service Processor System Monitoring - Surveillance" on
page 321.
7. Configure Call-In/Call-Out. See "Call-In/Call-Out Setup Menu" on page 308.
8. Exit the service processor menus.
9. Unplug the power cord from the system.
10. Attach modems (if needed). See "Accessing the Service Processor Menus
Remotely" on page 284.
11. Plug in the system.
Attention:
12. Test both of the following:
v Call-In, see "Testing Call-In" on page 486
v Call-Out, see "Testing Call-Out" on page 486
13. Use the "Save or Restore Hardware Management Policies," in the "Introduction to
Tasks and Service Aids" section of the RS/6000 Eserver pSeries Diagnostic
Information for Multiple Bus Systems to back up the service processor settings.
Note: This step is strongly recommended to protect the usefulness of the service
Your service processor is now ready for use.
This procedure applies to modems attached to the serial ports (S1, S2,
Make sure that system power remains off.
Make sure that the system power remains off.
processor and the availability of the system.
485