Table of Contents
Advertisement
Table 9. Common Firmware Error Codes (continued)
Error Code Description
B10F 1400 Service processor failure
B10F 1401 Service processor failure
B10F 1670 Service processor flash update failure
B10F 1672 Service processor firmware update
B10F 1675 Service processor failure
B10F 1681 Service processor firmware update
B10F 1682 Service processor firmware update
B10F 1683 Service processor firmware update
B1xx 0013 A firmware update has failed because
B1xx 4600 Service processor failure
B1xx 4601 System processor failure
B1xx 4602 Service processor firmware failure
B1xx 4603 Service processor firmware corrupted
Eserver pSeries 630 Models 6C4 and 6E4 Service Guide
260
invalid
invalid
invalid
invalid
the update image is invalid. The update
was stopped before any changes were
made to the currently installed firmware.
Action/
Possible Failing FRU
CEC backplane
Location: U0.1-P1
CEC backplane
Location: U0.1-P1
1. Retry flash update
2. CEC backplane
Location: U0.1-P1
Call service support
CEC backplane
Location: U0.1-P1
Call service support
Call service support
Call service support
Install a valid firmware image for the
specific type and model.
CEC backplane
Location: U0.1-P1
Go to "MAP 1540: Minimum
Configuration" on page 101.
1. Do a slow boot, see "Performing
Slow Boot" on page 153, then look
at the service processor error log.
Look for the first new error after the
B1xx 4602. Go to the "Checkpoint
and Error Code Index" on page 155
with the new error code and perform
the action indicated. If there are no
new error codes, go to "MAP 1540:
Minimum Configuration" on
page 101.
2. Call service support.
1. Reload system firmware
2. CEC backplane
Location: U0.1-P1
Advertisement
Table of Contents
