14. Remove the PCI riser card as described in "PCI Riser Card Removal" on
page 408.
15. Remove all hot-plug disk drives as described in "Hot-Plug Disk Drive Removal" on
page 405.
16. Remove the PCI adapter cooling fans as described in "Hot-Swap Fan Assembly
Removal" on page 393.
17. Remove the PCI adapter cooling fan stabilizing cage by loosening the retaining
screw located along the bottom back edge of the stabilizing cage.
18. Disconnect all power and signal cables connected to the disk drive backplane.
19. Remove the 4 retaining screws that secure the disk drive cage to the front of the
system chassis.
20. Slide the disk drive cage back until it clears the upper chassis ledge.
21. Pull the disk drive cage assembly out of the system.
22. Remove the 6 retaining screws attached to the disk drive backplane.
Chapter 9. Removal and Replacement Procedures
415