Table of Contents
Advertisement
3U storage server
The 3U storage server consists of one dx360 M3 system-board tray that is installed
in a 3U chassis. Depending on the server configuration, the 3U chassis supports up
to twelve 3.5-inch hot-swap SAS or SATA hard disk drives. The following illustration
shows twelve installed 3.5-inch hot-swap SAS hard disk drives.
Note: The hard disk drive bays in the system-board tray are not used in the 3U
storage server configuration.
Operator panel controls, connectors, LEDs, and power
This section describes the controls, connectors, and light-emitting diodes (LEDs)
and how to turn the system-board tray on and off.
Front view
The following illustration shows the controls, connectors, and LEDs on the front of
the server. The operator panel on the system-board tray is the same for all server
configurations.
Power-control button: Press this button to turn the system-board tray on and off
manually or to wake the system-board tray from a reduced-power state. Note that
the power-control button is recessed to prevent the system-board tray from being
turned on or off accidentally. There is a power-control button cover that can be
removed for easier access to the power-control button.
USB connectors: Connect USB 2.0 devices to these connectors.
Chapter 2. Components, features, and controls
19
Advertisement
Table of Contents
