IBM eserver 630 6C4 Service Manual page 165

Table 2. Firmware Checkpoints (continued)
Checkpoint Description
E5EE Hang state in main control code
E5EF End of low-level firmware
E600 SSA PCI adapter open firmware
has run successfully.
E601 SSA PCI adapter BIST has started
but failed to complete after 4
seconds.
E602 SSA PCI open firmware has
started.
E603 SSA PCI adapter BIST has
completed with an error.
E604 SSA PCI adapter BIST and
subsequent POSTs have completed
successfully.
E605 SSA PCI adapter BIST has
completed successfully but
subsequent POSTS have failed.
E60E SSA PCI open firmware about to
exit (no stack corruption).
E60F SSA PCI open firmware has run
unsuccessfully.
E6FF SSA PCI open firmware about to
exit (with stack corruption).
E700 Create system firmware VPD
E701 Create memory VPD.
E702 Create processor card VPD.
E703 Create operator panel VPD.
Action/
Possible Failing FRU
1. Check for system firmware
updates.
2. Go to "MAP 1540: Minimum
Configuration" on page 101.
1. Check for system firmware
updates.
2. Go to "MAP 1540: Minimum
Configuration" on page 101.
Replace the adapter.
Replace the adapter.
Replace the adapter.
Replace the adapter.
Replace the adapter.
Replace the adapter.
Replace the adapter.
Replace the adapter.
Replace the adapter.
System firmware may be corrupted.
Reinstall system firmware.
1. Check for system firmware
updates.
2. Call for support.
1. Check for system firmware
updates.
2. Call for support.
1. Check for system firmware
updates.
2. Call for support.
Chapter 4. Checkpoints
145