Table of Contents
Advertisement
Table 5. Firmware Error Codes. (continued)
Error Code Description
20EE 000F Unable to find the package node.
20EE 0010 Unable to execute the root VPD
method.
20EE 0011 Unable to execute the VPD method.
20EE 0012 Unable to execute the mem-dimm-VPD
method
20EE 0013 Unable to allocate memory for VPD.
20EE 0014 Unable to allocate memory for location
codes.
20EE 0100 Fcode resident on an I/O adapter is not
supported on this system
20FF 0001 Problem with VPD
2100 0xxx SCSI controller fault
Action/
Possible Failing FRU
1. Reboot the system.
2. Reflash the system with the latest
level of system firmware.
3. Call service support.
1. Reboot the system.
2. Reflash the system with the latest
level of system firmware.
3. Call service support.
1. Reboot the system.
2. Reflash the system with the latest
level of system firmware.
3. Call service support.
1. Reboot the system.
2. Reflash the system with the latest
level of system firmware.
3. Call service support.
1. Reboot the system.
2. Reflash the system with the latest
level of system firmware.
3. Call service support.
The system firmware may be corrupted.
Informational message. The adapter's
Fcode driver is not supported on this
system. Additional information may be
available from service support.
This error code only affects boot-time
operation, not the adapter's functionality
under the operating system.
1. Replace the part indicated by the
location code.
2.
If no location code is specified, call
service support.
1. Before replacing any system
components, refer to the notes in
error code 21A00001.
2. Replace the SCSI device.
Chapter 5. Error Code to FRU Index
169
Advertisement
Table of Contents
