IBM eserver 630 6C4 Service Manual page 155

Table 2. Firmware Checkpoints (continued)
Checkpoint Description
E134 Create memory node
E138 Create options node
E139 Create node aliases and system
aliases
E13A Create packages node
E140 Operating system load
E149 Create boot mgr node
E14C Create terminal-emulator node
E14D Loading boot image
E150 Create host (primary) PCI controller
node
E151 Probing primary PCI bus
E152 Probing for adapter FCODE,
evaluate if present
E153 End adapter FCODE,
probe/evaluate
E154 Create PCI bridge node
E155 Probing PCI bridge secondary bus
E156 Create PCI Ethernet node
Action/
Possible Failing FRU
Go to "MAP 1540: Minimum
Configuration" on page 101.
Go to "MAP 1540: Minimum
Configuration" on page 101.
Go to "MAP 1540: Minimum
Configuration" on page 101.
Go to "MAP 1540: Minimum
Configuration" on page 101.
See "Boot Problems/Concerns" on
page 150.
Go to "MAP 1540: Minimum
Configuration" on page 101.
Go to "MAP 1540: Minimum
Configuration" on page 101.
See "Boot Problems/Concerns" on
page 150.
If a location code is specified,
replace the adapter at that location
code.
If no location code is specified, go
to "MAP 1540: Minimum
Configuration" on page 101.
If a location code is specified,
replace the adapter at that location
code.
If no location code is specified, go
to "MAP 1540: Minimum
Configuration" on page 101.
Follow the repair action listed for
checkpoint E151.
Follow the repair action listed for
checkpoint E151.
Follow the repair action listed for
checkpoint E151.
Follow the repair action listed for
checkpoint E151.
If a location code is specified,
replace the adapter at that location
code. If no location code is
specified, go to "MAP 1540:
Minimum Configuration" on
page 101.
Chapter 4. Checkpoints
135