Table of Contents
Advertisement
Drawer Release Latch Bracket Replacement
To replace the Model 6C4 drawer release latches brackets, do the following:
1. If you have not already done so, open the front rack door and place the system into
the service position as described in "Placing the Model 6C4 into the Service
Position" on page 355.
2. Using the supplied retaining screws, secure the latch brackets to the side of the
Model 6C4.
Note: The latch brackets are right and left side dependent.
3. Replace the release latch as described in "Drawer Release Latch Replacement" on
page 352.
4. Replace the front bezel as described in "Front Bezel Replacement (Model 6C4)" on
page 369.
5. Push the system drawer back into the operating position as described in "Returning
the Model 6C4 to the Operating Position" on page 356.
Eserver pSeries 630 Models 6C4 and 6E4 Service Guide
354
Advertisement
Table of Contents
