Firmware Error Codes - IBM eserver 630 6C4 Service Manual

Table of Contents

Advertisement

Firmware Error Codes

Attention:
corrected, go to "MAP 1540: Minimum Configuration" on page 101 unless otherwise
indicated in the tables.
If you replace FRUs and the problem is corrected, go to "MAP 0410: Repair Checkout"
in the RS/6000 Eserver pSeries Diagnostic Information for Multiple Bus Systems .
Table 5. Firmware Error Codes.
Error Code Description
20A8 0000 Insufficient information to boot.
20A8 0001 The client IP address is already in use
20A8 0002 Cannot get gateway IP address.
20A8 0003 Cannot get system hardware address.
20A8 0004 Bootup failed.
20A8 0005 File transmission (TFTP) failed.
20A8 0006 Boot image too large
20D0 000F Self-test failed on a device, no error
20D0 0010 Self-test failed on a device, cannot
20D0 0011 Firmware RTAS attempt to allocate
20D0 0800 Firmware update failure
20D0 0801 System firmware update failure
20D0 0997 Operating system terminated with error
20D0 0998 Operating system terminated with error
20D0 0999 Operating system terminated with error
Eserver pSeries 630 Models 6C4 and 6E4 Service Guide
164
If you replace FRUs or perform an action and the problem is still not
by some other network device.
and/or location code information
available.
locate package
memory failed.
string
string
string
Action/
Possible Failing FRU
Verify the IP address.
Change IP address.
Refer to Table 2 on page 134 using
code E174.
Refer to Table 2 on page 134 using
code E174.
Refer to Table 2 on page 134 using
code E175.
Check network connection, try again.
Contact your next level of support for
assistance.
Refer to note "Mapping AIX and
Physical Location Codes" on page 37 to
see if a location code is available for
the device the error was reported
against.
1. Replace device indicated by the
location code (if available).
2. Go to "MAP 1540: Minimum
Configuration" on page 101
Contact your service support
representative for assistance.
Contact your next level of support for
assistance.
Retry the flash update.
Retry the firmware update.
Call service support.
Call service support.
Call service support.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eserver 630 6e4

Table of Contents