Table of Contents
Advertisement
Table 5. Firmware Error Codes. (continued)
Error Code Description
29B0 0004 Mouse not present/detected
2B20 0011 Processor is manually disabled
2B20 0022 Processor is deconfigured by the
2B20 0031 Processor is failing POST.
2B20 0042 Unknown processor card
2B20 8880 Unrecoverable internal hardware error
2B20 8881 Software error
2B20 8882 Software error
2B20 8883 Software error
2B20 8884 Unrecoverable processor subsystem
2B20 8885 Unrecoverable internal hardware error
2B20 8888 Operating system termination request
Eserver pSeries 630 Models 6C4 and 6E4 Service Guide
180
system
error
received
Action/
Possible Failing FRU
1. Mouse
2. Replace CEC backplane
Location: U0.1-P1
Use the service processor menus to
re-enable the processor and reboot the
system
The processor has previously failed
BIST or POST. Replace the processor
card indicated by the location code
associated with the error code in the
error log.
Replace the processor card indicated by
the location code associated with the
error code in the error log.
Remove the unknown/unsupported
processor card.
Replace the FRU indicated by the error
log entry.
Call service support.
Call service support.
Call service support.
Replace the FRU indicated by the error
log entry. If the system has been
rebooted, run diagnostics and look for
an AIX error log entry in which the
description says cache or cache
controller error. Replace the FRUs listed
in this entry.
Run diagnostics. Look for an AIX error
log entry in which the description says
I/O bus time out, access, or other error
or I/O bridge/device internal error.
Replace the FRUs listed in this entry.
Informational message.
Advertisement
Table of Contents
