Table of Contents
Advertisement
Table 4. SPCN Error Codes for the CEC (system unit) (continued)
Error Code Description
1011 8413
Invalid processor VPD
1011 8414
Invalid processor VPD
1011 8415
Invalid processor VPD
1011 8416
Invalid processor VPD
1011 8423
No processor VPD
1011 8424
No processor VPD
1011 8425
No processor VPD
1011 8426
No processor VPD
Firmware Error Codes
Attention:
If you replace FRUs or perform an action and the problem is still not corrected, go to "MAP
1548: Processor Subsystem Problem Isolation" on page 113 unless otherwise indicated in the tables.
If you replace FRUs and the problem is corrected, go to "MAP 0410: Repair Checkout" in the RS/6000
Eserver pSeries Diagnostic Information for Multiple Bus Systems.
Table 5. Firmware Error Codes.
Error Code Description
20A8 0000 Insufficient information to boot.
20A8 0001 The client IP address is already in use by some
other network device.
20A8 0002 Cannot get gateway IP address.
20A8 0003 Cannot get system hardware address.
20A8 0004 Bootup failed.
20A8 0005 File transmission (TFTP) failed.
20A8 0006 Boot image too large
20D0 000F Self-test failed on a device, no error and/or
location code information available.
20D0 0010 Self-test failed on a device, cannot locate
package
170
EserverpSeries 615 Service Guide
Action/
Possible Failing FRU
System backplane
Location: U0.1-P1
System backplane
Location: U0.1-P1
System backplane
Location: U0.1-P1
System backplane
Location: U0.1-P1
System backplane
Location: U0.1-P1
System backplane
Location: U0.1-P1
System backplane
Location: U0.1-P1
System backplane
Location: U0.1-P1
Action/
Possible Failing FRU
Verify the IP address.
Change IP address.
Refer to Table 2 on page 140 using code E174.
Refer to Table 2 on page 140 using code E174.
Refer to Table 2 on page 140 using code E175.
Check network connection, try again.
Contact your next level of support for assistance.
Refer to "Mapping AIX and Physical Location
Codes" on page 28 to see if a location code is
available for the device the error was reported
against.
1. Replace device indicated by the location
code (if available).
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 110
Contact your service support representative for
assistance.
Advertisement
Table of Contents
