Burr Wear Automatic Check; Water Softener Regeneration - Wega URBAN EVDP Manual

Problem
THE DISPLAY INDICATES A NON-
CONFORMING PRESSURE
COFFEE GROUNDS FOUND IN CUPS
THE CUP IS DIRTY WITH
COFFEE SPLASHES
• THE COFFEE IS NOT BEING
DISPENSED CORRECTLY
• THE COFFEE DOSE IS
NOT CORRECT
THE ELECTRONIC SYSTEM
HAS SHUTDOWN
WATER IS LEAKING FROM THE PUMP
THE MOTOR STOPS SUDDENLY
OR THE THERMAL PROTECTOR IS
TRIGGERED BY A POWER OVERLOAD
THE PUMP IS WORKING BELOW
THE NOMINAL FLOW RATE
THE PUMP IS NOISY

8.6 Burr wear automatic check

If enabled, this function displays a message to alert the user
that it is necessary to replace the grinder-dispenser burrs.
The warning appears when the amount coffee (kg) used
reaches the programmed limit.
The message will remain on the display in the selection stand-
by phase or the programming standby phase.
The alarm for reached/exceeded thresholds does not prevent
the machine from functioning.
The count can be reset at any time (even before the warning
is triggered) and by a technician.
The system only operates if the machine is paired
with a single grinder. Contact the Technician to
programme this function.
USER manual
Cause
Hydraulic system failure.
• The filter holder is dirty.
• The filter holes are worn.
• The coffee has not been ground evenly.
• The coffee has been ground too coarsely.
• The filter's edge is damaged.
The coffee has been ground too finely.
Electrical system or hydraulic system fault.
Pump fault.
Pump fault.
Pump fault.
Pump fault.
Action
Turn off the machine and call out the Technician.
• Clean the filter holder.
• Replace the filter.
• Adjust the grind as appropriate.
• Adjust the coffee grind.
• Replace the filter.
Adjust the coffee grind.
Turn off the machine and call out the Technician.
Turn off the machine and call out the Technician.
Turn off the machine and call out the Technician.
Turn off the machine and call out the Technician.
Turn off the machine and call out the Technician.

8.7 Water softener regeneration

The machine counts the water used and, where applicable,
when the expected amount is exceeded, the display indicates
the need to regenerate the softner.
The alarm for reached/exceeded thresholds does not prevent
the machine from functioning.
The count can be reset at any time (even before the warning
is triggered) by a technician.
Contact the Technician to programme this func-
tion. To regenerate the water softener, follow the
manufacturer's instructions.
URBAN
55 204
of