User-Settable Configurations; Beverage Dose Programming - Wega URBAN EVDP Manual

Energy Saving programming is only active when
the machine is set to PROG.
The PROG mode is indicated on the display as
shown in the drawings below.
7.3 User-settable configurations
The following items can be customised from the user configu-
ration menu, in addition to the Standby programming param-
eters:
Programme doses
-
Set services
-
Set the date and time
-
Blend selection
-
Screensaver
-
cloud settings
-
- Counter list
To make any modifications, proceed as follows:
• Access the menu (see para. 7.1 on page 47).
• Select the configuration button
• Press the button corresponding to the service to be set.
The machine menu can vary. This occurs should a
different version of the software be installed on
the machine; sometimes the software is also up-
dated even during maintenance to improve its performance.
USER manual
7.3.1
Use this menu to programme the coffee and hot water doses,
by proceeding as follows:
• Enter the user configuration menu and press the
• Select the dispensing group.
• Select the desired dose button (e.g. "1 espresso"
• Press the
• To confirm and stop the dose, press the
• Repeat this operation for the other dose buttons.
.
• You can copy the dose settings to the other groups by
pressing the
• To delete the dose settings, press the
• To manually adjust your dose, press the
buttons.

BEVERAGE DOSE programming

Do not remove the filter holder from the dispens-
ing group when coffee is being dispensed.
Each dose must be programmed with freshly
ground coffee and not with previously-used cof-
fee grounds.
dose programme button.
button to start dispensing.
button.
Start/End of dispensing
dose to be programmed
URBAN
).
button.
button.
and
Check the
programmed dose
Copies the dose
on all groups
Cancel dose
configuration
Manual dose
adjustment (ml)
49 204
of