Energy Saving System; Storage; Installation; Commissioning - Wega URBAN EVDP Manual

URBAN

2.9 Energy Saving System

The machine is equipped with software that manages the
automatic stand-by system during breaks, the night Energy-
saving feature and the smart temperature adjustment.
This allows saving a considerable amount of energy during
night breaks, whilst maintaining the machine in a condition
that permits a quickly return to operation.
Moreover, the software only distributes the power where and
when needed, thus allowing energy to also be saved during
normal operation.
If provided for in the programming, the software automati-
cally puts into stand-by one or more groups when the work-
load decreases, also preparing them for full capacity when
needed.
Three choices are provided:
• CONF: manual activation
• PROG: programmed operation
• ECO: self-learning management
To activate the Energy Saving mode, see para. 7.2
on page 47. For programming see par. 7 on page
47.

3. STORAGE

The machine is stored by the Manufacturer or Technician.

4. INSTALLATION

The machine must only be installed by the Technician.
When the machine is being installed, the Techni-
cian must replace the water in the hydraulic cir-
cuits.
The machine's support base must be perfectly flat,
not incline by more than 2° and have no irregulari-
ties.
The electrical system must be equipped with a
suitable residual-current device in compliance with
current laws and safety regulations.

5. COMMISSIONING

The machine must only be commissioned by the Technician.

6. OPERATION

6.1 Safety precautions

Carefully read the instructions provided in chapter
"I. SAFETY PRECAUTIONS" on page 31.
42 204
of

6.2 Emissions

Vibrations
Under conditions of use that comply with the instructions for
correct use provided in this manual, any detected vibrations
do not give rise to dangerous situations.
Sound emissions
The noise level emitted by the machine is on average lower
than 70 dB; therefore, the use of personal protective equip-
ment to prevent hearing damage is not compulsory.
If the machine emits any unusual sounds, the Technician
must be notified.
Electromagnetic environment
The machine is designed to work properly in any industrial
electromagnetic environment, falling within the Emission and
Immunity limits provided by current standards.

6.3 Turning the machine on and off

Before using the machine, run a few empty dis-
pensing cycles with the filter holder attached for a
few seconds to release any air inside the circuit
and in turn, allow the dispensing groups to fully heat up.
If the machine is inactive for longer than a week,
the Technician must replace 100% of the water in-
side the hydraulic circuits.
After the hydraulic and electrical mains have been connected
by the Technician, make sure that the drain tray under the cup
holder grille (11) is correctly connected to the drain.
5
11
Check that all the steam valves are closed. Turn the machine
on using the main switch (5) and follow the instructions pro-
vided on the display, as described below.
USER manual