Table of Contents
Advertisement
C h a p t e r 3 : C o n f i g u r i n g y o u r M a t r o x I r i s G T t o w o r k o n a n e t w o r k
1. Disconnect your Matrox Iris GT 100/1000 BaseT cable from your network.
2. Connect your Matrox Iris GT 100/1000 BaseT cable directly to your computer.
3. On your computer, launch the Matrox IrisBootParams utility. From the Matrox
C o n f i g u r i n g y o u r M a t r o x I r i s G T t o w o r k w i t h
a n e t w o r k t h a t u s e s D H C P
To configure your Matrox Iris GT to work with a network that uses DHCP, start
by verifying that the default settings of your Matrox Iris GT have not changed.
Your Matrox Iris GT is configured to use DHCP by default.
Check the LEDs of your Matrox Iris GT. If the power and user LEDs are both
green, your Matrox Iris GT is configured for DHCP. You should be able to access
the camera by name, using Internet Explorer:
http://IrisName
If, however, the power LED is green and the user LED is off, your Matrox Iris GT
uses a static IP address. In this case, you will need to configure your Matrox Iris GT
to use DHCP; to do so, proceed to the next subsection.
H o w t o c o n f i g u r e y o u r M a t r o x I r i s G T f o r D H C P
To configure your Matrox Iris GT so that it will obtain an IP address automatically
(that is, use DHCP), use the Matrox IrisBootParams utility, and perform the
following:
Imaging submenu of the Windows Start menu, select Design Assistant for Iris
GT. From the presented submenu, select Tools, and then click on Iris Network
and Boot Settings.
Advertisement
Table of Contents
