Table of Contents
Advertisement
A p p e n d i x G : M a t r o x I r i s G T u t i l i t i e s
1. Open a command prompt (DOS box) and type the following at the command
2. Before running either the FullRescue or IrisBackup utility, stop any running
3. At the command prompt, in the Telnet window, type the name of the utility along
U t i l i t i e s i n s t a l l e d o n y o u r M a t r o x I r i s G T
The following is a description of the utilities available on your Matrox Iris GT.
S t e p s t o r u n u t i l i t i e s i n s t a l l e d o n y o u r M a t r o x I r i s G T
To run the utilities installed on your Matrox Iris GT, perform the following:
prompt:
telnet IrisName
projects by performing the following:
a. Open Microsoft Internet Explorer and go to the Manage projects page of the
Matrox Iris portal website using the following address:
http://IrisName/manage_projects.asp
b. Terminate any running project by clicking on the project's Terminate project
button.
c. Verify that the Select the project you want to start on Iris start-up drop-down
list box is set to No project.
d. Close Microsoft Internet Explorer.
Before running either the FullRescue or IrisBackup utilities, create a
network-shared folder on your computer. This folder must be accessibly by your
Matrox Iris GT.
with the required parameters, and then press the Enter key.
Advertisement
Table of Contents
