Table of Contents
Advertisement
A p p e n d i x E : T h e b r e a k o u t b o a r d
1. Connect the gray, red, and yellow-brown wires of the digitial I/O and power cable
2. If only powering your Matrox Iris GT, wrap insulating tape around all the unused
3. Connect the digital I/O and power cable to your Matrox Iris GT.
4. Connect the external power supply, included in the Matrox Iris GT starter kit, to
5. Connect the external power supply to the DC power socket of the breakout board
P o w e r i n g M a t r o x I r i s G T a n d c o n n e c t i n g i t s
I / O s i g n a l s t o t h e b r e a k o u t b o a r d
To power your Matrox Iris GT and connect its I/O signals, perform the following:
to the J16, J17, and J15 terminal block connectors (receptacles) of the breakout
board's smart camera connector.
a. To insert a wire, press down on the orange flange with a small tool or pen.
b. Insert the un-insulated and tinned wire tip into the hole before releasing the
orange flange. The wire is now attached to the terminal block connector on
your breakout board.
wires of the Matrox Iris GT digital I/O and power cable. Otherwise, connect them
to the appropriate terminal block connectors of the breakout board's smart camera
connector; for information, see the Smart camera connector subsection of the
Open-wire connectors reference section (later in this chapter).
the power source.
power source connector (J18).
Advertisement
Table of Contents
