Introduction; Utilities Installed On Your Computer; Matrox Irisbootparams Utility - Matrox Iris GT Installation And Technical Reference

A p p e n d i x G : M a t r o x I r i s G T u t i l i t i e s
I n t r o d u c t i o n
The Matrox Iris GT utilities are a series of tools required to support all the
functionality of your Matrox Iris GT. Some are installed when you install Matrox
Design Assistant, while others come installed by default on your Matrox Iris GT.
U t i l i t i e s i n s t a l l e d o n y o u r c o m p u t e r
To launch the following utilities, go to the Matrox Imaging submenu of the
Windows Start menu. From the presented submenu, select Design Assistant for
Iris GT, and then select Tools.
M a t r o x I r i s B o o t P a r a m s u t i l i t y
The Matrox IrisBootParams utility allows you to connect to your Matrox Iris GT
using its MAC address. Once connected, you can change its IP address, subnet,
and network name as well as set it to use DHCP or automatic naming,
❖ Note that this utility works best if your Matrox Iris GT is directly connected to
your computer. If your Matrox Iris GT is plugged into a network and there are
routers between your Matrox Iris GT and your computer, this utility might not
be able to find your Matrox Iris GT.
To connect this utility to your Matrox Iris GT, perform the following:
1. On your computer, launch the Matrox IrisBootParams utility. From the Matrox
Imaging submenu of the Windows Start menu, select Design Assistant for Iris
GT. From the presented submenu, select Tools, and then click on Iris Network
and Boot Settings.