Table of Contents
Advertisement
A p p e n d i x E : T h e b r e a k o u t b o a r d
1. Connect the power and the digital I/O signals of your Matrox Iris GT to the
2. Connect an open-wire cable from the third-party device to the breakout board's
R o u t i n g a s i g n a l f r o m a t h i r d p a r t y d e v i c e t o y o u r M a t r o x I r i s G T
You can route a signal from a third-party device to your Matrox Iris GT. To do
so, perform the following:
breakout board by following the steps in the Powering Matrox Iris GT and
connecting its I/O signals to the breakout board section.
input connector.
To adjust for the various current requirements of trigger and auxiliary input
signals, a serial resistor must be added between the third-party device and the
breakout board's input connector. For more information, refer to Connecting
external devices to input signals section, in Appendix D: Using the I/O signals of
Matrox Iris GT.
Breakout board's
input connector
Serial resistor
Third-party device
(input-generating)
Advertisement
Table of Contents
