Table of Contents
Advertisement
A p p e n d i x E : T h e b r e a k o u t b o a r d
❖ Note that when routing output signals from the smart camera connector, the
1. Connect the power and the digital I/O signals of your Matrox Iris GT to the
2. Connect an open-wire cable from the strobe lamp to the breakout board's output
For more information about connecting inductive load devices, refer to Connecting
to an inductive load device subsection of the Connecting external devices to auxiliary
output signals section, in Appendix D: Using the I/O signals of Matrox Iris GT.
observed voltage at the output pin will be low when auxiliary output signals are
set to on and high when auxiliary output signals are set to off if there is an external
pull-up resistor connected. Without an external pull-up resistor connected, the
observed voltage at the output pin will be floating when auxiliary output signals
are set to off. For more information, see Connecting external devices to auxiliary
output signals section, in Appendix D: Using the I/O signals of Matrox Iris GT.
R o u t i n g a n a u x i l i a r y o u t p u t o r s t r o b e o u t p u t s i g n a l f r o m y o u r
M a t r o x I r i s G T t o a s t r o b e l a m p
You can route an auxiliary output signal or the current-controlled strobe output
signal from your Matrox Iris GT to a strobe lamp. To do so, perform the following:
breakout board by following the steps in the Powering Matrox Iris GT and
connecting its I/O signals to the breakout board section.
connector, as follows:
- If your strobe does not have its own power source, connect strobe output 0
(STB_CCS_OUT0) to the power connection of your strobe lamp. Connect
the ground of the strobe lamp to the J30 terminal block connector of the
breakout board's output connector.
Strobe
+V
GND
GND
Ring LED
-V
illuminator
Advertisement
Table of Contents
