Procmon Utility - Matrox Iris GT Installation And Technical Reference

• Error restoring FPGA ROM content. The firmware of the acquisition device in
your Matrox Iris GT could not be restored to its factory-configured state. Contact
Matrox Imaging technical support.
• Unable to connect to file server resource server name. Either the credential or file
server location are not valid for the server name provided.
• Cannot downgrade to this version with current hardware. The hardware of your
Matrox Iris GT and the rescue files do not match. To perform a rescue on your
Matrox Iris GT, you must use an older set of rescue files.
• Error finding file fname.ext. The specified file name can not be found in the given
path. The specified file is required for the rescue procedure to continue.
• Error formatting the SSD. The flash disk cannot be formatted. Contact Matrox
Imaging technical support.
• Error updating the OS in SSD. The operating system cannot be written to the
flash disk. Contact Matrox Imaging technical support.
P r o c M o n u t i l i t y
The ProcMon utility allows you to inquire about all running applications on your
Matrox Iris GT. It lists the threads and modules of each process, as well as the
CPU load of each thread. It can also be used to kill a process.
\>ProcMon [lproc lthread lmod lload kproc] [procid] [procarg] [-l]
P a r a m e t e r s
One of the following parameters can be used with the ProcMon utility:
• lproc. Lists all processes.
• lthread. Lists all threads in all processes or in one specified process. To specify one
process, use the procid parameter.
• lmod. Lists all modules in all processes or in one specified process. To specify one
process, use the procid parameter.
• lload. Lists the load in all the processes or one specified process. To specify one
process, use the procid parameter.
U t i l i t i e s i n s t a l l e d o n y o u r M a t r o x I r i s G T 1 2 5