Using The Matrox Irisbootparams Utility - Matrox Iris GT Installation And Technical Reference

With design assistant

Table of Contents

C h a p t e r 4 : C o n f i g u r i n g y o u r M a t r o x I r i s G T t o w o r k w i t h y o u r c o m p u t e r d i r e c t l y

C h a n g i n g t h e I P a d d r e s s o f y o u r M a t r o x

I r i s G T

A quick way to change the IP address and subnet mask of your Matrox Iris GT is

to use the Matrox IrisBootParams utility. This utility displays and allows you to

change the IP address, subnet mask, and network name of your Matrox Iris GT,

as well as the COM port settings. It also allows you to enable or disable DHCP

and automatic naming.

U s i n g t h e M a t r o x I r i s B o o t P a r a m s u t i l i t y

To use the Matrox IrisBootParams utility, perform the following:

1. On your computer, launch the Matrox IrisBootParams utility. From the Matrox

Imaging submenu of the Windows Start menu, select Design Assistant for Iris

GT. From the presented submenu, select Tools, and then click on Iris Network

and Boot Settings.

The Matrox IrisBootParams utility opens.

Table of Contents