Filter Uplink Enable; Filter Uplink; Filter Ethernet-Type Enable - SMC Networks EliteConnect SMC2891W-AG User Manual

7
Command Line Interface

filter uplink enable

This command enables filtering of MAC addresses from the Ethernet port.
Syntax
[no] filter uplink enable
Default
Disabled
Command Mode
Global Configuration
Example
SMC AP(config)#filter uplink enable
SMC AP(config)#

filter uplink

This command adds or deletes MAC addresses from the uplink filtering table.
Syntax
filter uplink <add | delete> MAC address
MAC address - Specifies a MAC address in the form xx-xx-xx-xx-xx-xx.
A maximum of four addresses can be added to the filtering table.
Default
Disabled
Command Mode
Global Configuration
Example
SMC AP(config)#filter uplink add 00-12-34-56-78-9a
SMC AP(config)#

filter ethernet-type enable

This command checks the Ethernet type on all incoming and outgoing Ethernet
packets against the protocol filtering table. Use the no form to disable this feature.
Syntax
filter ethernet-type enable
no filter ethernet-type enable
Default
Disabled
Command Mode
7-76