SMC Networks EliteConnect SMC2891W-AG User Manual page 77

802.11a/g outdoor enterprise access point
Hide thumbs Also See for EliteConnect SMC2891W-AG:
Table of Contents

Advertisement

• Range: 1-65535
• Default: Ethernet interface: 19; Wireless interface: 40
• Link Port Priority – Defines the priority used for this port in the Spanning Tree
Protocol. If the path cost for all ports on a switch are the same, the port with the
highest priority (i.e., lowest value) will be configured as an active link in the
spanning tree. This makes a port with higher priority less likely to be blocked if the
Spanning Tree Protocol is detecting network loops. Where more than one port is
assigned the highest priority, the port with lowest numeric identifier will be enabled.
• Default: 128
• Range: 0-240, in steps of 16
CLI Commands for WDS Settings – To set the role of the access point radio
interface, use the bridge role command from the CLI wireless interface
configuration mode. If the role of the radio interface is set to "Bridge" or "Repeater,"
the MAC address of the parent node must also be configured using the bridge-link
parent command. If the role is set to anything other than "Access Point," then you
should also configure the MAC addresses of the child nodes using the bridge-link
child command. To view the current bridge link settings, use the show bridge link
command.
Enterprise AP(if-wireless a)#bridge role bridge
Enterprise AP(if-wireless a)#bridge channel-auto-sync enable
Enterprise AP(if-wireless a)#bridge-link child 2
00-08-3e-84-bc-6d
Enterprise AP(if-wireless a)#bridge-link child 3
00-08-3e-85-13-f2
Enterprise AP(if-wireless a)#bridge-link child 4
00-08-3e-84-79-31
Enterprise AP(if-wireless a)#bridge-link parent
00-08-2d-69-3a-51
Enterprise AP(if-wireless a)#exit
Enterprise AP#show bridge link wireless a
Interface Wireless A WDS Information
====================================
AP Role:
Bridge
Channel Auto Sync:
Parent:
00-08-2d-69-3a-51
Child:
Child 2:
Child 3:
Child 4:
Child 5:
Child 6:
STAs:
No WDS Stations.
Enterprise AP#
Enable
00-08-3e-84-bc-6d
00-08-3e-85-13-f2
00-08-3e-84-79-31
00-00-00-00-00-00
00-00-00-00-00-00
Advanced Configuration
7-79
7-80
7-81
7-80
7-83
6
6-25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eliteconnect smc2890w-ag2890w-ag2891w-ag

Table of Contents