Show Bridge Stp - SMC Networks EliteConnect SMC2891W-AG User Manual

Default Setting
128
Command Mode
Interface Configuration
Command Usage
• This command defines the priority for the use of a port in the Spanning Tree
Protocol. If the path cost for all ports on a wireless bridge are the same, the
port with the highest priority (that is, lowest value) will be configured as an
active link in the spanning tree.
• Where more than one port is assigned the highest priority, the port with lowest
numeric identifier will be enabled.
Example
SMC AP(if-wireless a)#bridge-link port-priority 1 64
SMC AP(if-wireless a)#
Related Commands
bridge-link path-cost (7-88)

show bridge stp

This command displays aging time and spanning tree settings for the Ethernet and
wireless interfaces.
Syntax
show bridge stp
Command Mode
Exec
Example
SMC AP#show bridge stp
Bridge MAC
Status
priority
designated-root
root-path-cost
root-Port-no
Hold Time
Hello Time
Maximum Age
Forward Delay
bridge Hello Time
bridge Maximum Age
bridge Forward Delay :
time-since-top-change: 89185 Seconds
topology-change-count: 0
SMC AP#
: 00:12:CF:05:B7:84
: Disabled
: 0
: priority = 0, MAC = 00:00:00:00:00:00
: 0
: 0
: 1 Seconds
: 2 Seconds
: 20 Seconds
: 15 Seconds
: 2 Seconds
: 20 Seconds
15 Seconds
Spanning Tree Commands
7
7-89