Safety Compliance - SMC Networks EliteConnect SMC2891W-AG User Manual

802.11a/g outdoor enterprise access point
Hide thumbs Also See for EliteConnect SMC2891W-AG:
Table of Contents

Advertisement

Allowed 5GHz Channels in Each European Community Country
Allowed Frequency Bands
5 GHz Operation Not Allowed
* Outdoor operation is not allowed using 5.15-5.35 GHz bands (Channels 36 - 64).
Channels 36 - 64 are currently not available for use.

Safety Compliance

Power Cord Safety
Please read the following safety information carefully before installing the device:
Warning: Installation and removal of the unit must be carried out by qualified personnel
only.
• The unit must be connected to an earthed (grounded) outlet to comply with international
safety standards.
• Do not connect the unit to an A.C. outlet (power supply) without an earth (ground)
connection.
• The appliance coupler (the connector to the unit and not the wall plug) must have a
configuration for mating with an EN 60320/IEC 320 appliance inlet.
• The socket outlet must be near to the unit and easily accessible. You can only remove
power from the unit by disconnecting the power cord from the outlet.
• This unit operates under SELV (Safety Extra Low Voltage) conditions according to IEC
60950. The conditions are only maintained if the equipment to which it is connected also
operates under SELV conditions.
France and Peru only
This unit cannot be powered from IT
must be powered by 230 V (2P+T) via an isolation transformer ratio 1:1, with the
secondary connection point labelled Neutral, connected directly to earth (ground).
Impédance à la terre
Important! Before making connections, make sure you have the correct cord set. Check
it (read the label on the cable) against the following:
iv
Allowed Channel Numbers
None
supplies. If your supplies are of IT type, this unit
Countries
Greece

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eliteconnect smc2890w-ag2890w-ag2891w-ag

Table of Contents