Administration - SMC Networks EliteConnect SMC2891W-AG User Manual

6
System Configuration
CLI Commands for AP Management features.
SMC AP(config)#apmgmtip multiple 192.168.1.50 255.255.255.0
SMC AP(config)#apmgmtui SNMP enable

Administration

Changing the Password
Management access to the web and CLI interface on the access point is controlled
through a single user name and password. You can also gain additional access
security by using control filters (see "Filter Control" on page 6-17).
To protect access to the management interface, you need to configure an
Administrator's user name and password as soon as possible. If the user name and
password are not configured, then anyone having access to the access point may
be able to compromise access point and network security. Once a new Administrator
has been configured, you can delete the default "admin" user name from the system.
Username – The name of the user. The default name is "admin." (Length: 3-16
characters, case sensitive)
New Password – The password for management access. (Length: 3-16 characters,
case sensitive)
Confirm New Password – Enter the password again for verification.
CLI Commands for the Administrator's User Name and Password – Use the
username and password commands from the CLI configuration mode.
SMC AP(config)#username bob
SMC AP(config)#password admin
SMC AP#
Setting the Timeout Interval
You can set the timeout interval for web access to the unit, after which the user will
have to re-enter the username and password.
6-28
7-21
7-22
7-15
7-15