Table of Contents
Advertisement
Setting the Country Code – Units sold in the United States are configured by
default to use only radio channels 1-11 in 802.11b or 802.11g mode as defined by
FCC regulations. Units sold in other countries are configured by default without a
country code (i.e., 99). You must use the CLI to set the country code. Setting the
country code restricts operation of the access point to the radio channels and
transmit power levels permitted for wireless networks in the specified country.
Type "exit" to leave configuration mode. Then type "country ?" to display the list of
countries. Select the code for your country, and enter the country command again,
following by your country code (e.g., tw for Taiwan).
SMC AP#country tw
SMC AP#
Note: Command examples shown later in this manual abbreviate the console prompt to
"AP" for simplicity.
Logging In
There are only a few basic steps you need to complete to connect the access point
to your corporate network, and provide network access to wireless clients.
The access point can be managed by any computer using a web browser (Internet
Explorer 5.0 or above, or Netscape 6.2 or above). Enter the default IP address:
http://192.168.2.2
Logging In – Enter the username "admin," the password is null, so just press just
leave it blank and click LOGIN. For information on configuring a user name and
password, see page 6-28.
5
Logging In
5-3
Advertisement
Table of Contents
