Table of Contents
Advertisement
4
Hardware Installation
1.
Pan the antenna horizontally back and forth while checking the LEDs. If using
the pole-mounting bracket with the unit, you must rotate the mounting bracket
around the pole. Other external antenna brackets may require a different
horizontal adjustment.
2.
Find the point where the signal is strongest (all LEDs on) and secure the
horizontal adjustment in that position.
Note: Sometimes there may not be a central lobe peak because vertical alignment is too
far off; only two similar peaks for the side lobes are detected. In this case, fix the
antenna so that it is halfway between the two peaks.
3.
Loosen the vertical adjustment on the mounting bracket and tilt the antenna
slowly up and down while checking the LEDs.
4.
Find the point where the signal is strongest and secure the vertical adjustment
in that position.
4-10
Advertisement
Table of Contents
