Menu Code 99: Unit Of Measure - Bennett 3000 Series Operation Manual

3.42 MENU CODE 99: UNIT OF MEASURE

Set the unit of measurement and the number of decimal locations required for the currency in use. This
Menu Code also allows viewing of the meter calibration values without having to move the calibration
switch in Menu Code 27.
Keypad
Action
99, Mode
1, 2, or 3
Enter, Enter
2 or 3
Enter, Enter
Enter
Enter
Cancel
To set the unit of measurement, press the appropriate key below and press Enter.
Key
1
2
3
During initial setup, the factory default setting of "1000th" and "0" should appear in the Display. The "0"
(or whichever number appears) indicates the number of times this setting has been changed.
To set the decimal location, press the appropriate key below and press Enter.
Key
2
3
3000 Series Operation Manual
Retail Display Volume Only
Results Display Results
G A L L O N
0
- - G A L L O N G A L - 0
o r
- - L i t E r -
o r
- - b i - G A L
G A L L O N
0
t h - -
1 0 0
h u n d - 0
o r
t h - -
1 0 0 0
T h o u - 0
1 0 0 0 t h
0 0 , 0 0
C A 1 A 0 0 , 0 0
E C A L 1 A
-
C O d E
S i d E - - 1
0 0
Unit of Measure
(Default) U.S. Gallons
Liters
British Imperial Gallons
Decimal Location
100 th (volume resolution – liters ".01")
th
1000 (volume resolution – gallons ".001") - (Default)
Back to TOC
Description
Default is 0. See steps 1-3
G A L 0
below.
Change to desired unit of
o r
measure. See step 1
L i t - 0
o r below.
b i 6 - 0
Saves selection, moves to
G A L 0
next step.
Change decimal location.
o r
See steps 2 and 3 below.
Saves selection, moves to
T h o u 0
next step.
Calibration value that was
entered in Mode 27.
To toggle through all
-
selection if needed.
Exit Menu Code
Setup and Programming
59