Bennett 3000 Series Operation Manual page 54

To run an ATC test sale:
• Switch the calibration switch toward the middle of the 719 board, which is the unsealed
position.
Steps
1
2
•
Lift nozzle and lever (if applicable).
•
Select product (if applicable).
3
•
Dispense fuel into desired
receptacle.
The main display will show (for example):
4
The PPV display will show the temperature.
The display may show:
4a
A t C C O L D o r A T C H O T
The display may show:
4b
5
•
Lower Lever (if applicable)
6
•
Replace nozzle
7
8
9
10
3000 Series Operation Manual
ATC Test
Press: 37, Mode
Press: ↑
C 2 0 . 3 4 3
U 2 0 . 0 0 2
E R R 3
p r o b e A
T O O C O L D
+/-
Press Cancel
↑
Press
Press Enter
Press Cancel
Back to TOC
Description
The display will show:
AtC 1A
dISAbLED
The display will show:
AtC
rEAdy
Power ON the dispenser to initiate a sale.
C = Compensated Volume
U = Uncompensated Volume
The temperature is out of rage if the display
shows all dashes. Meaning the temperature
is lower than -30 ° or higher than +40 ° .
If running a sale outside of the temperature range, the
sale will stop. Errors may also indicate a failed probe.
Troubleshoot if necessary.
Toggles to actual sale information during the test.
End the ATC test and record data.
Returns to Commodity Group.
Prepares to run another ATC test.
To select another product.
Exit Menu Code
Setup and Programming
50