Default Settings - Bennett 3000 Series Operation Manual

3.3 DEFAULT SETTINGS

The dispenser is programmed in production with default settings in some menu codes. Some menu
codes must be changed immediately to make the dispenser operational, refer to Section 3.6.2 Initial
Setup Sequence. The default settings are listed below:
Menu
Code
3 Manager Access
4 Prices
7 Dispenser Type
8 Decimal Location
9 No Flow Time Out
10 Slow Flow Amount
11 Volume Allocation
Submerged Pump, Last Sale, Idle, and Handle
12
State Timer
14 Price Display
15 Fleet Option
16 Battery Timeout
17 Local Preset
18 Motor Delay
20 Masked Volume
21 Communication Type
22 Dispenser Address
24 Solenoid Valve Type
27 Meter Calibration
28 Rounding
31 Total Access
37 ATC Measurement
49 Software Reboot
50 Pulse Output
60 End Condition Prepay Sale
70 Marina Pulser Enable Delay
80 Cycle Valves
86 Hi/Lo Selectable Switch
96 Proportional Valve
99 Unit of Measure
3000 Series Operation Manual
Name
Back to TOC
2218
0000
Sides = 2, Grades = 1, Hoses = 1, Tier = 1
0 = U.S.A.
--- = Infinite Time
0.200 Volume Unit (Gallons) / 0.600 Volume Unit (Liters)
0999 Volume Units
Pre-Charge = 2 seconds, Last Sale = 30, Idle = 15, Handle State = 0
0 = Flashing, 0 = Dash, Flip = 0
0 = Disabled Fleet Interface
30 Seconds
0 = No Preset
0 = No Delay (Self contained suction systems only)
.010 gallons or .10 liters (International only)
0 = Console Mode
0 = Only one dispenser on the communications loop
2 = Proportional Valve
0.00
1 = Rounding the Sale Amount
1 = Access allowed without manager password
0 = Long
0 = Off
0 = Disabled
0 = Cash Drawer
0 Seconds
0 = Off
Standard Flow = 10 gpm /38 lpm or High Flow = 60 gpm / 227 lpm
Start of Sale = 35 percent, End of Prepay Sale = 35 percent
1 = Gallons, 1 – Decimal position 3 places
Setup and Programming
Default
13