Ommunication Type - Bennett 3000 Series Operation Manual

3.25 MENU CODE 21: COMMUNICATION TYPE
NOTE: In this menu code if programming with two fueling sides also program the other side.
NOTE: A Personality Module is required to allow communication. Refer to the 3000 Installation Manual
on our website at www.bennettpump.com.
Communication protocol is established by the POS. The dispenser has four communication protocol
options, or it can be programmed to self-authorize in Stand-Alone without a POS console intervention
(typically used during maintenance and troubleshooting).
Communication Protocol programming options:
• 0 = Current Loop (Default)
• 1 = Stand-Alone
• 2 = RS485
• 3 = Generic Loop
• 4 = Fleet RS485
To program, follow this procedure:
• Passcode required, see Section
Keypad Retail Display
Action Results
21, Mode
C U r r N t
L O O P
S t A N d -
1
A L O N E -
r 5 4 8 5 -
2
- - - -
G E N E r C
3
L O O P - -
F L E E t
4
r S 4 8 5
C U r r N t
0
L O O P
G E N E r C
Enter
L O O P
C O d E
Cancel
3000 Series Operation Manual
3.4 Menu Code 3: Manager
Volume Only
Display Results
C r N t L O O P
S t N d - A L N
R S 4 8 5
G E N E r I C
F L t - 4 8 5
C r N t L O O P
G E N E r i C
C O d E 0 0
0 0
Back to TOC
Access.
Lower PPV
Display Results
Current Loop (default).
In the following actions:
Type desired setting listed
C O d E
above, 0-3, and then
C O d E
C O d E
C O d E
C O d E
C O d E
Enter saves option.
Generic Loop shown as an
C O d E
S i d E -
Setup and Programming
Description
Enter.
Stand Alone
RS485
Generic Loop
Current Loop
example.
Exit Menu Code
36