Bennett 3000 Series Operation Manual page 15

Menu
Name
Code
21 Communication Type
22 Dispenser Address
24 Solenoid Valve Type
26 Shift Totals
27 Electronic Calibration
28 Rounding
29 Resettable Totals
30 Real Time Clock
31 Total Access
35 Upper X19 CPU MD5
36 Lower I/O CPU MD5
37 ATC Measurement
49 Software Reboot
50 Pulse Output
Clear EEPROM
58
End Condition Prepay
60
Sale
Marina Pulser Enable
70
Delay
78 Def Satellite Handle
80 Valve Diagnostics
81 Motor Diagnostics
Proportional Valve
96
Unit of Measure
99
3000 Series Operation Manual
Access
Description
Type
Passcode Set the dispenser to stand-alone or console modes.
Passcode Set the dispenser address.
Passcode 2 = Proportional Valve
Passcode Reset shift totals.
Cal Switch Electronically calibrate the dispenser.
Passcode Set the sale amount to round or truncate.
Passcode Enter a value for each meter on the dispenser (volume total).
Passcode Set current time and date.
Passcode Access mode 1 and mode 2.
Passcode View the Upper X19 CPU MD5 Checksum
Passcode View the Lower I/O Board MD5 Checksum
Passcode Program ATC measurement. Canada only.
Passcode Reboots the software.
Passcode Set the pulse unit, pulse ratio, and pulse speed (PPS).
Cal Switch Can initialize every memory location in the 25xx256 EEPROM to
0xFF. This mode erases the non-volatile memory. This mode can
only be accessed when the calibration switch is in the unsealed
position.
Passcode Change the end condition of a prepay sale in decimal mode 5.
Passcode Program a delay between the valves and pulsers.
This mode allows the user to select the satellite pump handle
input position.
The satellite pump handle position can be programmed from 0 to
Passcode 2: 0 = disabled, 1 = handle A, 2 = handle B.
When the satellite handle position is other than zero, the satellite
pump handle can be used to start a sale without activating the
master pump handle.
Passcode Tests the valves.
Passcode Tests the motors.
Passcode Program the valve settings for starting a sale and ending a
prepay/preset sale.
Passcode Set the dispenser to gallon or liter, decimal placement, and view
electronic calibration.
Back to TOC
Setup and Programming
11