Table of Contents
Advertisement
Operation
Display illumination
20
mission
The meter automatically switches off the display illumination if no key is
pressed for 30 seconds. The illumination is switched on with the next keystroke
again.
You can also generally switch the display illumination on or off (see section
11.2.1 S
, page 70).
YSTEM
5.4
Navigation
The principles of navigation in menus and dialogs are explained in the following
sections.
5.4.1
Operating modes
The instrument has the following operating modes:
Operating
Explanation
mode
Measuring
The measurement data of the connected sensor are shown
in the measured value display
Calibration
The course of a calibration with calibration information, func-
tions and settings is displayed
Storing in
The meter stores measuring data automatically or manually
memory
Transmit-
The meter transmits measuring data and calibration records
ting data
to a USB-B interface automatically or manually.
Setting
The system menu or a sensor menu with submenus, set-
tings and functions is displayed
Only those displays and functions are available in the active operating mode
that are currently being required.
5.4.2
Measured value display
In the measured value display, open the setting menus with
functions of the softkeys are shown on the display.
<OK>
Use
(short pressure) to open the menu for calibration and measure-
ment settings for the displayed measured parameter.
_
<OK
>
Use
(long keystroke (approx. 2 s) to open the Storage & config
menu with the sensor-independent settings.
Use the keys of the keypad to carry out further functions such as storage or cali-
bration (see section 5.1.1 K
in other operating situations.
, page 17). These functions are not available
EYPAD
MU 6100 H
<OK>
. The current
ba77077e06
05/2021
Advertisement
Table of Contents
