Navigation - wtw Multi 3410 Operating Manual

Multi 3410
Measured value display
Menus and dialogs
ba75863e02 12/2009

4.2.2 Navigation

In the measured value display, you can
open the menu for calibration and measurement settings with
<MENU/ENTER> (short keystroke)
open the Storage & config menu with the sensor-independent set-
tings by pressing <MENU/ENTER
change the display in the selected measuring window (e. g. pH <−>
mV) by pressing <M>.
The menus for settings and dialogs in procedures contain further sub-
menus. The selection is made with the < >< > keys. The current
selection is displayed with a frame.
Submenus
The name of the submenu is displayed at the upper edge of the
frame. Submenus are opened by confirming with <MENU/ENTER>.
Example:
System
General
Interface
Clock function
Service information
Reset
22.09.2009 08:00
Settings
Settings are indicated by a colon. The current setting is displayed on
the right-hand side. The setting mode is opened with <MENU/
ENTER>. Subsequently, the setting can be changed with < >< >
and <MENU/ENTER>. Example:
General
Language:
Beep:
Volume
Illumination:
Brightness:
Switchoff time:
Temperature unit
Calibration data storage
22.09.2009 08:00
Functions
_
> (long keystroke, approx. 2 s).
Deutsch
Off
9
On
12
1 h
°C
On
Operation
25