Settings For Orp Measurements - wtw VWR MU 6100 H Operating Manual

MU 6100 H
ba77077e06 05/2021
3. Confirm the setting with
4. Quit the menu with

11.1.4 Settings for ORP measurements

The settings for ORP measurements are made in the menu for calibration and
measurement settings of the pH/ORP measurement. To open the settings, dis-
play the required measured parameter in the measured value display and
<OK>
press the key. After completing the settings, switch to the measured
<MODE>
value display with
In the following table, only those settings are listed that influence the ORP mea-
surement.
Default settings are printed in bold.
Menu item
Man. temperature
Resolution mV
Reset
<OK>
.
<MODE>
.
.
Possible Explanation
setting
Entry of the manually determined
-25 ... +25 ...
temperature. For measurements
+130 °C
without temperature sensor only.
0.1 Resolution of the mV display
1
Resets all sensor settings to the
-
delivery condition (see section
11.3.1 R
MENT SETTINGS
Settings
ESETTING THE MEASURE
, page 71).
-
63