wtw VWR MU 6100 H Operating Manual page 72

Settings
pH
Oxi
Cond
72
with the Reset function:
Setting
Buffer
Calibration interval
Unit for slope
Measured parameter
Resolution pH
Resolution mV
Asymmetry
Slope
Man. temperature
One point calibration
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open it in the measured value display,
<OK> <F1>
press the (or
The calibration data are reset to the default settings together with
the measuring parameters. Recalibrate after performing a reset.
The following settings for D.O. measurements are reset to the default settings
with the Reset function:
Setting
Kal.-Intervall
Comparison meas.
Measured parameter
Relative slope (S
Rel
Salinity (value)
Salinity (function)
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open it in the measured value display,
<OK> <F1>
press the (or
The following settings for conductivity measurements are reset to the default
Default settings
TEC
7 d
mV/pH
pH
0.001
0.1
0 mV
-59.2 mV
25 °C
No
/[Menu]) key.
Default settings
14 d
Off
D.O. concentration
1.00
)
0,0
Off
/[Menu]) key.
MU 6100 H
ba77077e06 05/2021